Visit the ST website and navigate to STSW-LINK009, as indicated in. ST-LINK Driver for Windows (32/ 64-bit versions 7, 8, and 10): It is available on the STs website. The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontrollers. The STSW-STM32102 software package contains four installation files based on the various versions of the Microsoft ® operating system. ST-Link in-circuit debugger and programmer. Remember, the correct installation of the ST-Link driver is of utmost importance upon obtaining your board. The ST-Link driver means the driver for the ST-Link in-circuit debugger and programmer interface, as depicted in Figure 1. In order to communicate with the board over UART, you use the ST-Link Virtual COM Port interface, and your host application or host IDE uses STMicroelectronics STLink dongle interface, which is an interface used for debugging. When your Nucleo board is connected, a COM port will be visible under “Ports,” and the “STMicroelectronics STLink dongle” option will appear in “USB devices” (Figure 8) Very often Ill find myself with a device like a Particle Photon, Wilderness Labs Meadow, or some STM32 device that uses the ST Bootloader. STM32 Flash Loader (for flashing via FTDI) KISS FC Manual v1.06 (English). Upon completion of the installation, click “Finish” (Figure 7).įigure 6. These drivers are used if you are having issues connecting your flight controller to your PC. The software will install the WinUSB driver (Figure 6), which is required in order to talk to the ST-Link, and it also installs other drivers.Within it, you’ll find two applications (Figure 4), one for 32-bit and the other for 64-bit systems. Upon downloading, access the folder where the driver is stored.ST-Link driver installation link for Windows. You will get a USB driver for those boards with ST-LINK/V2 and ST-LINK/V2-1 ST-Link circuitry.Īt the end of the website, you will find the driver link (Figure 3), and proceed to download it. Visit the ST website and navigate to STSW-LINK009, as indicated in Figure 2.ST-LINK Driver for Windows (32/ 64-bit versions 7, 8, and 10): ST-Link in-circuit debugger and programmer. I tried to download STM32 installer for windows 11 from this page. The ST-Link driver means the driver for the ST-Link in-circuit debugger and programmer interface, as depicted in Figure 1. Once you have your ST board that may be either discovery, Nucleo, or any other board from ST, which is based on ST-Link in-circuit debugger and programmer, then in order to talk to the board successfully, you have to install the ST-Link drivers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |